(805) 456-5980

Made in USA Since 1987

SuperTie™

Fiberglass Form-Tie System

Say goodbye to corrosion forever. Easier to use, saves time, and less expensive than traditional steel form ties.

SuperTie™

Fiberglass Form Tie System

Say goodbye to corrosion forever. Easier to use, saves time, and less expensive than traditional steel form ties.

SuperTie™

Fiberglass Form Tie-System

In ½”, ¾”, and 1” diameters,
offering strengths of up to
15,000, 30,000, and 34,000 lbs.

SuperTie™ Patented Coil Rod System

Eliminate corrosion and rust stains while reducing man-hours and costs.

SuperTie™ patented fiberglass form tie-systems are used to secure concrete formwork during concrete placement and initial hydration, without the inherent limitations and rusting of previously popular steel form-tie systems. RJD SuperTie™ can be manufactured in a broad array of colors. The RJD fiberglass tie will never rust therefore no breakback removal or snap-tie cone patching is ever required, creating superior architectural finishes. There’s a significant reduction of wall-forming labor costs when using the SuperTie™ fiberglass form-tie system, and it works well with anything from handset wall forms to crane-set gang-form systems.

SuperTie™ CRFF 0500 (1/2”)

SuperTie™ Coil Rod Form Fixture 1/2” offers an ultimate tensile strength of 15,000 pounds (7,500 pounds safe working load at 2:1 safety factor) and is most commonly used with job-built (plywood and 2×4) forms and handset modular forms. The fiberglass rod diameter is 1/2” making the system compatible with most commercial forming systems.

SuperTie™ CRFF 0750 (3/4”)

SuperTie™ Coil Rod Form Fixture 3/4” offers an ultimate tensile strength of 30,000 pounds (15,000 pounds safe working load at 2:1 safety factor) and is most commonly used with job-built (plywood and 2×4) forms and handset modular forms. The fiberglass rod diameter is 3/4″ making the system compatible with most commercial forming systems.

SuperTie™ CRFF 1000 (1”)

SuperTie™ Coil Rod Form Fixture 1” offers an ultimate tensile strength of 34,000 pounds (17,000 pounds safe working load at 2:1 safety factor) and is most commonly used with job-built (plywood and 2×4) forms and handset modular forms. The fiberglass rod diameter is 1” making the system compatible with most commercial forming systems.

Non-Corrosive Fiberglass Coil Rod

RJD Fiberglass Coil Rod utilizes a specially blended and formulated custom-engineered resin, made in the USA, combining ultimate tensile strength and the RJD Form Fixture (CRFF) strength. (Do not use any non-RJD engineered rod with RJD grippers; this could result in form failure and/or injury.) RJD Fiberglass Coil Rod will never rust, eliminating the need for breakback, plugging and patching allowing for superior architectural finishes. RJD Fiberglass Coil Rod is offered in ½”, ¾”, and 1” diameters.

SuperTie™ Coil Rod Accessories

SuperTie™ Bearing Plate BP615 & BP300

The Bearing Plate is a required component with the SuperTie Coil Rod Form Fixture. The BP615 is a 4”x4” steel plate with a 5/8”-diameter hole and fits the 1/2″ Coil Rod. The BP300 is a 5”x5” steel plate with a 1 1/8”-diameter hole and fits the 3/4” and 1” Coil Rod.